In the previous video, we learned how to make RC series cables.
Today, we will guide you through learning " How to remove pins from RC series wire connectors " .
First, let's understand the connection principle of connectors.
Taking " motor power output cable " as an example, after the connector terminal is inserted into the " motor power output cable connector " , the spring claw inside the connector will automatically abut against the connector terminal and lock it.
Therefore, we must use a professional pin removal tool – a " pin remover " – to lift the clamping claws that hold the terminal in place, thereby achieving perfect pin removal.
"1-353715-2" terminal pin retraction
The following three types of cables in the RC series use "1-353715-2" type terminals .
○ Motor power output cable
○ Power input cable
○ Control power input cable
The specific needle removal process is as follows:
Insert the " pin ejector " into the " wire connector " (using the " motor power output wire connector " as an example) with the orientation shown in the diagram below.
1. Confirm connector orientation
2. Confirm the direction of the needle ejector.
Insert the " pin ejector " into the connector as shown in the diagram above . The front end of the " pin ejector " will push up the locking claw to " unlock " the connector, allowing the terminal to be ejected.
3. Needle removal process
"1827570-2" terminal pin retraction
The other three types of cables in the RC series use the "1827570-2" type terminal .
○ Motor brake output cable
○ Module control I/O cables
○ Encoder cable
The specific needle removal process is basically the same as that of the "1-353715-2" type terminal .
1. Confirm connector orientation
2. Confirm the direction of the needle ejector.
3. Needle removal process
That concludes today's technical sharing.
If you have any content you are interested in
Feel free to leave us a message
Maybe next time
Then it appeared.
