Today we will introduce the usage steps of the DEKWELL EX series card-type I/O digital modules.
01. Using PROFINET communication in TIA Portal software
1. The actual physical address allocated by EX-202H
2. EX-202H IO Variable Table
3. CH1 Mode Switching and Counting Enable
4. Write the initial value of CH1
5. Clear CH1 counter value
02. Using EtherCAT communication in CODESYS software
1. CH1 Channel Mode Switching and Counting Enable
2. Write the initial value of CH1
3. Clear CH1 counter value
03. Using Sysmac Studio software
1. CH1 Mode Switching and Counting Enable
2. CH1 Mode Switching and Counting Enable
3. Clear CH1 counter value
04. Using Ethernet/IP communication in CODESYS software
1. Hardware Configuration
2. Input/output byte configuration
3. The I/O address corresponding to the module
Note: When the slot position of the module is changed, the physical address of the corresponding IO module will also change.
4. CH1 Channel Mode Switching and Counting Enable
5. Write the initial value of CH1
6. Clear CH1 counter value
05. Control Timing Diagram
