The newly upgraded FC 360 boasts a wealth of software features, maximizing uptime and increasing reliability. Its built-in standard flux vector control mode effectively enhances dynamic performance, benefiting various applications such as torque control, boosting functions, and PM motor closed-loop control. This comprehensively improves its control capabilities and greatly expands its application areas.
The standard flux vector control mode is implemented in a factory-activated mode. Entering the authorization number will activate and allow you to use this function. The activation method and steps are detailed below:
◀Confirm Authorization Number▶
01. Confirm via inverter nameplate
02. Confirm via inverter parameters
Parameters can be queried via LCP:
• 15-46 Inverter Part Number (PN)
The serial numbers in the image above are for illustrative purposes only.
Please operate according to the actual authorization number of the machine.
• 15-51 Inverter Serial Number (SN)
The serial numbers in the image above are for illustrative purposes only.
Please operate according to the actual authorization number of the machine.
◀Enter the authorization number via MCT 10 ▶
01. Connect the MCT 10 to the frequency converter.
02. Confirm the PN and SN numbers of the frequency converter.
03. Activate via parameter P3057
• Before the standard flux vector control mode is activated, reading the parameters of 3056 should display "NULL", as shown in the figure below.
• Write the obtained license to the drive via Par.3057, as shown in the figure below, by entering EZ2W-ZQS3-E8CN-9DAM.
• After entering the correct license, press Enter. You can then check if the standard flux vector control mode is activated by reading the value of Par.3056[0]. If Par.3056[0] displays "FluxControl", then activation is successful. After successful activation, the result shown in the figure below will be displayed.
• After successful input, execute powercycle. The first power-on will take a slightly longer time.
• Read Par.3056 and Par.3057, as shown in the figure below.
Note: Par.3057 will be empty after power-on. Do not use this parameter to determine whether it is activated.
◀Important Notes▶
Save the authorization information. If the frequency converter is damaged or the control card is replaced in the future, you will need to re-enter the authorization number to restore the activation state of the standard flux vector control mode.
By following these steps, users can ensure that the FC 360's standard flux vector control mode is correctly activated, thereby fully utilizing its high-performance control capabilities and bringing you a better application experience.
